General Warnings and Cautions
The following general warnings and cautions are applicable to Vescent instruments.
WARNING
This instrument is intended for use by qualified personnel who
recognize shock hazards or laser hazards and are familiar with
safety precautions required to avoid possible injury. Read the
instruction manual thoroughly before using to become familiar
with the instrument’s operations and capabilities.
CAUTION
There are no serviceable parts inside the instrument. Work
performed by persons not authorized by Vescent may
void the warranty.
CAUTION
Although ESD protection is designed into the instrument,
operation in a static-fee work area is recommended.
WARNING
To avoid electrical shock hazard, connect the instrument to
properly earth-grounded, 3-prong receptacles only. Failure to
observe this precaution can result in severe injury or death
WARNING
Do not clean outside surfaces of any Vescent products
with solvents such as acetone. Front panels on electronics
modules may be cleaned with a mild soap and water solution.
Do not clean optics modules.
 | Never connect or disconnect the D2-105 Laser Controller to/from a laser with the D2-105 energized. Always power down the D2-105 completely before making connections to the laser. |
| | Any input/output connections to the SLICE instrument must be derived from a Safety Extra Low Voltage (SELV) source. |
| If this instrument is used in a manner not specified by the manufacturer in this manual or other relevant literature, protection provided by the instrument may be impaired. |
| | Never connect either of the TEC leads on a plant or the SLICE-QTC to ground. This configuration is very likely to cause severe damage to the SLICE-QTC. |